There are a lot of reasons why a piece of certain machinery is hindered from working.
When this happens, the surest reason is that something is broken inside it.
The parts that make up an object sometimes tire out and flatly refuse to work.
A garage door typically has a wide variety of parts and hardware that work behind the scenes.
These parts are connected together and make up the whole system for the function of your garage doors.
When it does not work properly and refuses to open or close, you can bet that either of those components is malfunctioning, resulting in calling for a garage door repair.
If your garage door won’t open, there is a strong chance that the cables are keeping it from doing its job.
The broken wires might be the culprit for your distress.
Oftentimes you won’t even notice that a cable has been torn until the door malfunctions.
Then there is the question of safety due to the breakdown.
Unexpected troubles occur when cables snap.
If you are having trouble getting your door up, the following might be the reason why the broken cables are keeping your garage door from opening.
It is affecting the torsion spring cables.
They are placed above the door opening.
When the doors go down, the wires connected towards the bottom side of the doors result in the springs winding up.
When it is opened, the springs unwind and it helps the garage door up.
When the cables are broken, it makes it difficult to lift the door open.
It is causing trouble for the extension spring cables.
The springs linked to the cable are called the extension springs, which is stretched when the doors are closed.
On the other hand, when the doors are opened, these springs help in lifting.
If the cables supporting these springs are broken, they prevent them from going back into place and hinder the door from opening.
The safety cables are broken.
It is the job of the safety wires to prevent a spring that has been broken from disengaging from the garage door.
This may result in severe damage or injury to those who are around.
They are usually linked to the track of the door or the wall beside the system of pulleys.
Safety cables wrap through the springs and attach to the support where the spring is also connected.
When this breaks, a serious injury may befall the person near it since nothing keeps the springs from being disentangled.
The cables are winded into the drum incorrectly.
The improper winding of the cables into the drum can cause a jam in the doors’ opening.
This might be why you are prevented from opening the door.
The wrapping of the wires into the cables in the wrong form can cause a severe issue and frustration.
The cables are unwounded.
Check to see if the cables have become unwounded.
If they are, you need to replace it immediately.
There is no use in repairing them.
Sometimes, it is better to entirely chuck the old one out and bring in a new one to ensure that your garage door will open if you command it to for a long time.
The door falls right back down when it opens.
You are in for serious trouble when this happens.
It is not because the photo-eye is broken but because the cables are cut.
When broken wires attempt to open the door, it will go down as quickly as it went up.
You know that the cables have snapped or there was a tearing behind the scenes when this occurs.
You could jeopardize the safety of your family with this.
Hence, you should immediately call for a technician to replace the cables.
What to do when this happens?
- Do not attempt to use the door.
- Remove the broken cable.
If you are skilled in the matters of home repairs and have experience with handling wires, you can try to remove the cord on your own.
- Ask for a replacement.
Repairs are only temporary.
If you want to make sure it doesn’t happen again, replace the cables immediately.