Table of Contents
When something does not work, it needs to be replaced.
There is no point in holding on to it as it might only damage you in the long run.
In times like this, you need to salvage what you can to keep the other things unharmed.
Salvage what you can in order to keep the other vital parts intact.
The same goes for your garage door.
The cable allows the door to operate smoothly in terms of opening and closing.
It keeps it together and holds it so that it stays afloat.
Most of the functions of the garage door are made possible by the springs and cable handling it.
Behind the scenes, they do perhaps the most critical work to make sure the door operates properly.
The cable has the responsibility of seizing the author when the springs refuse to hold off somehow.
There are three types of cables for garage doors: torsion springs, extension springs, and safety cables.
Each has its own function and, when they give up, it can cause severe damage that will require you to do some garage door repair.
To prevent that, here are five reasons why you need your garage door cable to be replaced:
1. It’s wearing off
Your cables move every time the garage door moves as well.
They move through pulleys or end up in a drum cable.
Due to this, they may be worn out brought upon by the moisture located near the bottom of the garage door.
The faulty pulleys may also contribute to the wearing of these cables.
When the door is unadjusted, these cables also rub on the other components.
To check this, inspect the cable and replace them immediately before the worst happens.
Examine it for rust, corrosion, and the like.
2. They are winded around the drum improperly
When cables are wrapped around the cable drum in an incorrect manner, they become jammed together.
When this happens, the garage door sags to one area.
You should consider replacing the cables for the door to function correctly.
Wires need to work correctly for the door to operate smoothly without any problems.
3. They are beginning to fray
To recognize whether a cable is already fraying, check to see if the wires are broken and are starting to break apart from each other.
When you notice the fraying, replace them immediately.
Otherwise, when they break, while the door is moving, it can go sideways or fall off track.
When this happens, the other components may be damaged as well.
The inspection of the loop on the cable that is connected to the foot bracket is vital.
You can see that the loop and the bracket are straddled on the bottom of the panel at the foot of the garage located on both sides.
The primary function of the loops is to link the cable, drums and springs to the garage door.
4. The pulleys are worn out
Cables are affected when there is something wrong with the pulleys.
When they are worn out, it is more likely that they have also caused the wires to wear out too.
Hence, when you replace the pulleys, you have to do the same thing for the cables too.
Do not attempt to repair them and only replace the wires because they can still wear out all over again and, in turn, affect the cables also.
Hence, you need to replace them once more.
It is best to buy something new so that you will be guaranteed that it will not damage for a long time.
5. It’s subject to tearing
If your garage door cable is already old and is showing signs of tearing, don’t wait for it to snap.
Cords grow tired and weary for a period of time, especially for years of holding up the door.
Just like any other parts, they are also subject to wearing and may need immediate attention.
If you feel like the cable is already old, you should take the time to get a new one installed.
It may not be causing problems for you now but, most likely, it will show defects in the near future.
If you live in Mississauga, Markham, Newmarket, or Toronto, consider calling your garage door repair company for help in the replacement.